Autodesk Acquires Firehole Composites, Extending Its Analysis Software Portfolio

Not just resting on its cash reserves or other recent acquisitions, Autodesk announced that it has completed the acquisition of Firehole Technologies (DBA Firehole Composites), a privately held company that specializes in design and analysis software for composite materials. Through this acquisition, Autodesk will expand its analysis software portfolio to work with light, strong, and complex composite materials. Firehole Composites is based in Laramie, Wyoming, also the home of the University of Wyoming, and a town with an incredibly low unemployment rate of 3.4%.

“As manufacturers move to more complex material such as light weight composites, new simulation technology is required to predict and optimize the performance of these materials. This acquisition will enable Autodesk to deliver this technology to a broad spectrum of design and engineering industries,” said Buzz Kross, senior vice president for Design, Lifecycle and Simulation products. “The Firehole team will add significant expertise in next generation materials and non-linear analysis, as well as industry-leading technologies that strongly complement our solutions for structural, thermal and plastics analysis.”

Engineered composites are complex materials made from two or more  materials with widely different physical and/or chemical properties. When combined, the constituents produce a material with characteristics much different than the individual components. Interestingly, though, (and this adds to the mystique behind composites), the individual components remain separate and distinct within the finished structure. Even though it’s been around a long time, today, still the most common composite material is concrete. Because composites are complex materials, simulating and analyzing them and their behavior is a very computationally demanding proposition.

Check out the video for CompositePro for FEA that demonstrates some of the tools availble to support composite finite element analysis process. Among other things, CompositePro can be used to:

• Determine ply-level or laminate-level material properties for 2D shell or 3D solid element analyses
• Investigate complex failure modes of stuctures such as tubes or sandwich panels to understand when they will fail

Autodesk says it intends to sell and support the existing Firehole Composites product line, as well as integrating the composites analysis technology more tightly with Autodesk products. No surprise there, especially the latter. As usual, and not unexpectedly, terms of the transaction were not disclosed.

Tags: Autodesk, composites, FEA, Firehole Composites

This entry was posted on Wednesday, March 20th, 2013 at 12:23. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.