45th DAC a Success with Attendees and Exhibitors

ANAHEIM, Calif.—(BUSINESS WIRE)—June 11, 2008— The 45th Design Automation Conference (DAC), the electronic design automation (EDA) industrys premier event, has attracted thousands to the Anaheim Convention Center this week. Preliminary numbers indicate total attendance has surpassed 8,000 so far this week, with attendees visiting the 215 exhibitors represented. The 45th DAC exhibits will be open through Thursday, June 12 from 9am to 1pm.

This years preliminary attendance figures break down into the following categories:

DAC Exhibit-only attendees: 2,405
DAC Technical conference (workshops, tutorials, etc.) attendees: 2,423
DAC Exhibitor personnel: 3,550
Preliminary total 45th DAC attendance: 8,468

These numbers are very similar to last year. Final attendance numbers will be announced later this month and are expected to be slightly adjusted.

The ballroom was packed, with people filling the aisles during the opening session and the keynote presentation by Justin Rattner, Intel, CTO, said Limor Fix, general chair, 45th DAC Executive Committee. The biggest challenges and opportunities of our industry in the wireless market, analog design, sw/hw co-design, verification and manufacturing are the topics of many of DACs well-attended sessions and events this year. Once again, DAC is the place where electronic design meets.

The 46th DAC will be held July 2631, 2009 in San Francisco.

About DAC

The Design Automation Conference (DAC) is recognized as the premier event for the design of electronic circuits and systems, and for Electronic Design Automation (EDA) and silicon solutions. A diverse worldwide community representing more than 1,500 organizations attends each year, from system designers and architects, logic and circuit designers, validation engineers, CAD managers, senior managers and executives to researchers and academicians from leading universities. Close to 60 technical sessions selected by a committee of electronic design experts offer information on recent developments and trends, management practices and new products, methodologies and technologies. A highlight is its Exhibition and Suite area with approximately 250 of the leading and emerging EDA, silicon and IP providers. The conference is sponsored by the Association for Computing Machinerys Special Interest Group on Design Automation (ACM/SIGDA), the Circuits and Systems Society and Council on Electronic Design Automation of the Institute of Electrical and Electronics Engineers (IEEE/CASS/CEDA) and the Electronic Design Automation Consortium (EDA Consortium). More details are available at: www.dac.com.



Contact:

Weber Shandwick
Emily Taylor, 503-552-3733
Email Contact




Review Article Be the first to review this article

Featured Video
Editorial
Jeff RoweJeff's MCAD Blogging
by Jeff Rowe
Siemens Goes ECAD With Mentor Graphics Acquisition
Jobs
Mechanical Engineer for IDEX Corporation at West Jordan,, UT
Business Partner Manager for Cityworks - Azteca Systems, LLC at Sandy, UT
GIS Analyst II for Air Worldwide at Boston, MA
Senior Structural Engineer for Design Everest at San Francisco, CA
Upcoming Events
Design & Manufacturing, Feb 7 - 9, 2017 Anaheim Convention Center, Anaheim, CA at Anaheim Convention Center Anaheim CA - Feb 7 - 9, 2017
Innorobo 2017 at Docks de Paris Paris France - May 16 - 18, 2017
Display Week 2017 at Los Angeles Convention Center 1201 S Figueroa St Los Angeles CA - May 21 - 26, 2017



Internet Business Systems © 2016 Internet Business Systems, Inc.
595 Millich Dr., Suite 216, Campbell, CA 95008
+1 (408)-337-6870 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering EDACafe - Electronic Design Automation GISCafe - Geographical Information Services TechJobsCafe - Technical Jobs and Resumes ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy Policy Advertise