sRAM generator HAUMEA at 90 nm on DOLPHIN Integration's website

Grenoble. November 17, 2008. The winning performance mix BCD, Best for Consumption and Density, is heralded by the new sRAM Haumea generator at 90 nm LP process.

It represents the cornerstone of Dolphin Integration's embedded memory strategy at a time when Foundry Pushed Rule bit-cells and the trap of "free libraries" stifle design creativity.

Haumea BCD can generate RAMS from 16 kbits to 512 kbits.

Until now it was not feasible to reach the best of two advantages at once: either a wide reach of generator "cuts", or a finely tuned memory instance. A new breed of compilers was needed and DOLPHIN Integration did it:

Haumea is indeed built from a pre-optimized interpolation compiler enabling at once the best dynamic consumption reduction and the best area with increased speed whatever the capacity targeted!

Not only this, but Haumea is unique in that its Read-Margin is automatically optimized for each instance:

Haumea indeed accounts for each specific configuration in terms of capacity and multiplexing, so as to guarantee maximum design yield in fabrication. This comes in contrast with fixing a unique Read-Margin or, even worse, letting the user set it at his own risk.

The 65 nm Haumea is coming soon.
With Haumea, cost reduction and low-power are neatly compatible!

About Dolphin
Dolphin Integration is up to their charter as the most adaptive creator in Microelectronics to "enable mixed signal Systems-on-Chip", with a quality management stimulating reactivity for innovation.

Their current mission is to supply worldwide customers with fault-free, high-yield and reliable sets of CMOS Virtual Components, resilient to noise and drastic for low power-consumption, together with engineering assistance and product evolutions customized to their needs.

DOLPHIN Integration SA with social Capital of 1,295,120 € - www.dolphin.fr
ISIN: FR0004022754/ ALDOL - Bloomberg: ALDOL FP - Reuters: ALDOL.PA
ICB 9576. Semiconductors.

Contacts:
Michel DEPEYROT, Executive Chairman - Email Contact
ATOUT CAPITAL, Listing Sponsor,
Cedric BEUDIN, (33) 1 56 69 61 83 - Email Contact



Review Article Be the first to review this article
SolidCAM: Program your CNCs directly inside your existing CAD system.


Featured Video
Editorial
Jeff RoweJeff's MCAD Blogging
by Jeff Rowe
Siemens Goes ECAD With Mentor Graphics Acquisition
Jobs
Mechanical Engineer for IDEX Corporation at West Jordan,, UT
GIS Analyst II for Air Worldwide at Boston, MA
Senior Structural Engineer for Design Everest at San Francisco, CA
Business Partner Manager for Cityworks - Azteca Systems, LLC at Sandy, UT
Upcoming Events
Design & Manufacturing, Feb 7 - 9, 2017 Anaheim Convention Center, Anaheim, CA at Anaheim Convention Center Anaheim CA - Feb 7 - 9, 2017
Innorobo 2017 at Docks de Paris Paris France - May 16 - 18, 2017
Display Week 2017 at Los Angeles Convention Center 1201 S Figueroa St Los Angeles CA - May 21 - 26, 2017



Internet Business Systems © 2016 Internet Business Systems, Inc.
595 Millich Dr., Suite 216, Campbell, CA 95008
+1 (408)-337-6870 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering EDACafe - Electronic Design Automation GISCafe - Geographical Information Services TechJobsCafe - Technical Jobs and Resumes ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy Policy Advertise