InventorCAM Basics - Part 1 "Programming"
This is the second class in a series of classes. Some of the topics covered
in "InventorCAM Basics" include; geometry selection methods, toolpath cutting options,
open vs. closed boundaries, templates, and much more. This class is a must if you are
new to InventorCAM and continues where the "Introduction to InventorCAM" class
leaves off. This will give you a greater foundation to learning InventorCAM and simplify
future training courses.
| Reserve your Webinar Seat For : 8:00 AM - 9:00 AM PDT
| Reserve your Webinar Seat For : 11:00 AM - 12:00 PM PDT
Required: Windows® 7, Vista, XP or 2003 Server
Required: Mac OS® X 10.6 or newer
Required: iPhone®, iPad®, Android™ phone or Android tablet